Fisher & Paykel Ranges F2-E0 Error: Oven temperature runaway
Fisher & Paykel range error code F2-E0 is a high-severity fault meaning Oven temperature runaway — cavity overheating. An oven temperature runaway is a fire hazard. A power-cycle will clear the display code, but the underlying fault that caused runaway heating will not be resolved by a reset.
~40%
DIY Fixable
From $150
Typical Repair Cost
1–3 hrs
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
No. An oven temperature runaway is a fire hazard. Do not use the range until the root cause — shorted RTD sensor, stuck relay, or failed element — is identified and corrected. Continued use risks igniting food residue or oven insulation.
Can I reset the code?
No. A power-cycle will clear the display code, but the underlying fault that caused runaway heating will not be resolved by a reset. The oven will run away again on the next heating cycle. Physical repair is mandatory before returning the range to service.
When to stop immediately?
Stop if you notice: Any sign of smoke, fire, or scorching inside the oven cavity, Code returns on the first heating cycle after reset.
Symptoms You May Notice
F2-E0 displayed during baking or broiling
The code appears mid-cycle when the oven cavity temperature exceeds the upper safety threshold, typically above 590°F (310°C).
Oven shuts down during use
As a safety response the E.R.C. cuts power to the bake and broil elements (or closes the gas valve on dual-fuel models) and displays F2-E0.
Strong heat or scorching smell from oven
Food may scorch or smoke before the cutout activates because the oven overshot the set temperature significantly.
Possible Causes
Shorted RTD oven temperature sensor
A short-circuit in the RTD sensor causes the E.R.C. to read an artificially low oven temperature, so it continues heating past the safe limit.
DIY PossibleFaulty E.R.C. relay stuck closed
The bake or broil relay on the control board has welded shut, supplying continuous power to the heating element even when commanded off.
Requires ProfessionalFailed bake element with internal short
A shorted bake element draws excessive current and generates more heat than the circuit intends, outpacing the sensor feedback loop.
DIY PossibleSafe Checks You Can Do
-
1
Power off the range immediately
Switch off the range circuit breaker at the panel. Do not attempt to open the oven door if smoke is present — wait for the cavity to cool with the door closed.
Allow at least 30 minutes of cooling before any inspection.
-
2
Inspect the RTD sensor probe
After the oven has cooled completely, locate the RTD probe (a thin metal rod protruding into the oven cavity from the rear wall). Check for visible damage, cracking of the ceramic sheath, or contact with a rack or pan.
Physical contact between the sensor and a cooking vessel is a common cause of a false low-reading short.
-
3
Test RTD sensor resistance
With the range unplugged, disconnect the RTD sensor leads and measure resistance with a multimeter. Fisher & Paykel oven RTD sensors typically read approximately 1,080–1,100 Ω at room temperature (68°F / 20°C).
A reading significantly below 1,080 Ω or near zero confirms a shorted sensor requiring replacement.
Tools required
When to Call a Professional
Contact a qualified technician if:
- RTD sensor tests good but runaway recurs — board relay is the likely cause
- Bake or broil element shows visible damage or continuity to ground (shorted)
- Any scorch marks visible on the control panel or oven liner
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Ranges Repair Service Schedule Appointment