Fisher & Paykel Wine Refrigeration DR Error: Door open alarm
Fisher & Paykel wine cellar error code DR is a low-severity fault meaning Door open alarm. A door alarm does not affect the cabinet's mechanical function. The DR alarm clears automatically once the door is properly closed and the door sensor confirms closure.
~85%
DIY Fixable
From $60
Typical Repair Cost
15–60 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. A door alarm does not affect the cabinet's mechanical function. As long as the door is closed and the zone temperature is within range, the cabinet is safe to use. Address the underlying cause — gasket wear, leveling, or a faulty door sensor — at your earliest convenience to prevent unnecessary temperature fluctuations.
Can I reset the code?
Yes. The DR alarm clears automatically once the door is properly closed and the door sensor confirms closure. If DR persists with the door firmly closed, the door sensor or gasket requires attention.
When to stop immediately?
Stop if you notice: DR alarm cannot be cleared and zone temperature is rising above 65°F (18°C), Door gasket is visibly torn and allowing significant warm air ingress.
Symptoms You May Notice
DR displayed with alarm tone
The panel shows DR and an audible alarm sounds after the door has been open for approximately 60 seconds.
Zone temperature rising
With the door open, warm room air enters the cabinet and wine temperatures begin to climb.
Alarm persists with door closed
If the door sensor or seal is faulty, DR may appear even though the door appears closed.
Possible Causes
Door genuinely left open
The most common cause — the door was not fully closed after accessing the cabinet.
DIY PossibleWorn or damaged door gasket
The magnetic door gasket has hardened, torn, or lost its seal, preventing a complete close and triggering the door sensor.
DIY PossibleCabinet not level
An unlevel installation causes the door to hang open slightly under its own weight rather than swinging closed.
DIY PossibleFaulty door magnetic switch
The magnetic reed switch or hall-effect sensor that detects door closure has failed, reporting the door as open when it is closed.
Requires ProfessionalSafe Checks You Can Do
-
1
Confirm the door is fully closed
Press the door firmly closed and ensure no wine bottles, labels, or packaging are preventing full closure. The UV-protective glass panel should seat flush against the gasket on all four sides.
Wine labels or foil capsules on protruding bottles are a frequent cause of partial door closure.
-
2
Check cabinet levelness
Place a spirit level on top of the cabinet. Adjust the leveling feet so the cabinet tilts 1–2° back toward the wall — this allows the door to self-close under gravity.
Fisher & Paykel wine cabinets are designed to self-close from a 90° open position when correctly leveled.
-
3
Inspect the door gasket
Run a finger around the full perimeter of the door gasket and check for tears, hardened sections, or areas where the gasket has pulled away from the door frame. Close the door on a piece of paper — it should grip firmly all the way around.
A worn gasket can often be re-energized temporarily by warming with a hair dryer on low heat, but replacement is the permanent fix.
When to Call a Professional
Contact a qualified technician if:
- Door sensor (reed switch or hall-effect) tests faulty with a multimeter or magnet test
- Door hinge has sagged and requires hinge adjustment or replacement
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Wine Refrigeration Repair Service Schedule Appointment