Fisher & Paykel Ovens F8 Error: Convection element fault
Fisher & Paykel oven error code F8 is a mid-severity fault meaning Convection element (fan heater) open-circuit fault. Standard bake and broil modes that do not use the convection ring element are unaffected by an F8 fault. F8 caused by a physically open-circuit convection element will not clear with a power-cycle.
~55%
DIY Fixable
From $140
Typical Repair Cost
1–2 hrs
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. Standard bake and broil modes that do not use the convection ring element are unaffected by an F8 fault. Continue using these modes normally, but schedule element replacement before the next time fan-bake cooking is required.
Can I reset the code?
No. F8 caused by a physically open-circuit convection element will not clear with a power-cycle. The element must be replaced before the fault code clears and fan cooking modes become available again.
When to stop immediately?
Stop if you notice: Visible arcing or sparking from the rear element area, F8 appears during non-fan bake modes (suggests a board relay fault affecting bake circuit).
Symptoms You May Notice
F8 shown in fan cooking modes
The code appears when fan bake or fan-forced modes are selected; standard bake using only the bottom bake element may still function.
Oven takes much longer to reach temperature
Without the convection ring element, the oven relies solely on the bake element, causing slower and uneven heating in fan mode.
Fan runs but oven barely heats
The convection fan motor operates normally but air circulating through the cavity is not being heated by the ring element.
Possible Causes
Failed convection ring element
The circular heating element surrounding the fan at the rear of the oven has burnt out, creating an open circuit in the element winding.
DIY PossibleElement connection terminal loose or burnt
The push-on terminal connecting the element to the supply wiring has overheated, arced, and lost contact.
DIY PossibleControl board relay fault
The relay on the main PCB powering the convection element has failed open, preventing current from reaching the element.
Requires ProfessionalSafe Checks You Can Do
-
1
Confirm bake mode still works
Select a standard bake mode and verify the oven heats normally. If the bake element works, only the convection ring element circuit is at fault.
You can continue using the oven in standard bake and broil modes while sourcing a replacement convection element.
-
2
Visually inspect the convection element
With the oven cool and unplugged, remove oven racks and use a torch to inspect the circular heating element at the back of the oven cavity. Look for a visible break, blister, or burn mark on the element coil.
A small dark spot or crack in the element sheath is a reliable indicator of element failure, even without a multimeter.
-
3
Test element continuity
With the oven unplugged, access the rear of the element terminals (this may require pulling the oven out slightly) and measure continuity or resistance across the element connections. A healthy convection element reads 15–40 Ω; an open circuit (OL) confirms the element has failed.
Also inspect the push-on terminals for heat discolouration or melting, which indicates arcing at the connection point.
Tools required
When to Call a Professional
Contact a qualified technician if:
- Convection ring element replacement requires removing the rear oven wall panel
- On models where element terminals are accessible only from the back exterior of the built-in unit, partial oven extraction is needed
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Ovens Repair Service Schedule Appointment